| |
Issue No:6, Vol.3 |
June - 2010 |
ISSN: 0974-5645 |
| RESEARCH ARTICLES |
Viewers & PDF |
| 3. The verification of adiabatic model of a lateral sliding bearing with a floating ring bearing. Aleksander Mazurkow (2010) Indian J.Sci.Technol. Vol. 3, Issue 6, pp: 620-626. Domain site: http://www.indjst.org. |
 
|
- Abstract
This research work describes the adiabatic model of a lateral slide bearing with a floating ring bearing. In order to
support recommended assumptions for a designed model and for an evaluation accuracy of achieved results, the
author developed a verification method which let comparing results received in a numerical way with that of the ones
received in experimental tests. The evaluation criteria of a theoretical model were presented in regard to results from
empirical studies. These criteria were divided into three groups. As the basic criteria, the author accepted the position
of a bearing journal centre towards a fixed bearing bush, also for these positions pressure and temperature
distributions in the outer oil film were chosen. In the conclusion, suggestions were made about the comparison of
pressure and temperature distributions, frictional moments on a fixed bush surface, and angular velocities of a floating
ring bearing towards a fixed bearing bush. The reasons of differences between measured and calculated values were
also discussed.
- Keywords: Floating ring bearing, bearing load, oil film, adiabatic model, eccentricity ratio.
|
| |
|
|
|
